Engine Flywheel Installation (Manual Transmission)

WARNING: This page is about a different car, the 2002 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.

Tools Required: J 36660-A Torque Angle Meter

Install the flywheel.
Install the new flywheel bolts.
Tighten:

Tighten the bolts to 15 N.m (11 lb ft). Use J 36660-A to tighten the bolts an additional 50 degrees

Fig 1: Engine Flywheel Installation (Manual Transmission)
Courtesy of GENERAL MOTORS CORP.