Crankshaft Balancer Removal

Tools Required: 

• J 37096  Flywheel Holding Tool
• J 38197-A  Crankshaft Balancer Puller

1. Use J 37096 in order to hold the flywheel.
   Fig 1: Use J 37096 In Order To Hold The Flywheel

   Courtesy of GENERAL MOTORS CORP.
2. Remove the crankshaft balancer bolt.
   Fig 2: Crankshaft Balancer Bolt

   Courtesy of GENERAL MOTORS CORP.
3. Use the J 38197-A in order to remove the crankshaft balancer.

   Important:  Do not separate the crankshaft pulley from the crankshaft balancer. Service the crankshaft pulley and the crankshaft balancer as an assembly.

   1. 3.1. Invert J 38197-2 so the leg of the tool is facing away from the crankshaft balancer.
   2. 3.2. Install the silver screws J 38197-4 to the crankshaft balancer.
   3. 3.3. Turn J 38197-1 to remove the crankshaft balancer from the crankshaft.
   4. 3.4. Remove J 38197-1, J 38197-2, and J 38197-4 from the crankshaft balancer.
   Fig 3: Removing Crankshaft Balancer

   Courtesy of GENERAL MOTORS CORP.