Test Description
WARNING: This page is about a different car, the 2002 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
The number(s) below refer to the step number(s) on the diagnostic table.
- 2. The noise may not be engine related. This step is to verify that the engine is making the noise. If the engine is not making the noise do not proceed further with this table.
- 3. The noise may be an internal engine noise. Remove the drive belt and operate the engine for a brief period, this will verify if the chirping noise is related to the drive belt. With the drive belt(s) removed the water pump may not operate and the engine may overheat. Also DTCs may set when the engine is operated with the drive belt removed.
- 4. Inspect all drive belt pulleys for pilling. Pilling is the small balls or pills or it may be strings in the drive belt grooves from the accumulation of rubber dust.
- 6. Misalignment of the pulleys may be caused from improper mounting of the accessory drive component, incorrect installation of the accessory drive component pulley, or the pulley may be bent inward or outward from a previous repair. Test for a misaligned pulley using a straight edge in the pulley grooves across two or three pulleys. If a misaligned pulley is found, refer to that accessory drive component for the proper installation procedure for that pulley.
- 10. Inspection of the fasteners can eliminate the possibility that a wrong bolt, nut, spacer, or washer was installed.
- 12. Inspecting the pulleys for being bent should include inspecting for dents or other damage to the pulleys that would prevent the drive belt from not seating properly in all of the pulley grooves or on the smooth surface of a pulley when the back side of the belt is used to drive the pulley.
- 14. Replacing the drive belt when it is not damaged or there is not excessive pilling will only be a temporary repair.