LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 55 (Automatic Transaxle Diagnosis - 4T65-E) >> Removal & Installation >> STOPLAMP Switch >> Installation

STOPLAMP Switch: Installation

WARNING: This page is about a different car, the 2002 Buick Regal, 2002 Buick Century, 2001 Buick Regal, and 2001 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the stoplamp switch (2) to the brake pedal bracket. See Fig 1 .
  2. Connect the electrical connector to the stoplamp switch.
  3. Adjust the stoplamp switch.
    4. CAUTION: Inspect the left sound insulator for the proper clearance to the accelerator and brake pedals. Improper clearance may result in binding of the accelerator or brake pedals.
  4. Install sound insulator in the following order:
    1. Position the insulator to the vehicle. Install the insulator to the stud at the accelerator pedal.
    2. Rotate the courtesy lamp clockwise in order to connect the courtesy lamp to the insulator.
    3. Install the insulator tabs to the lower instrument panel trim pad retainers.
Fig 1: Locating Stoplamp Switch
G00073409Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals