LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 55 (Automatic Transaxle Diagnosis - 4T65-E) >> Removal & Installation >> Input Shaft Speed Sensor >> Removal

Input Shaft Speed Sensor: Removal

WARNING: This page is about a different car, the 2002 Buick Regal, 2002 Buick Century, 2001 Buick Regal, and 2001 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the case side cover. See appropriate AUTOMATIC article in TRANSMISSION SERVICING.
  2. Disconnect the transaxle wiring harness.
  3. Remove the input speed sensor clip (441) from the case cover. See Fig 1 .
  4. Remove the input speed sensor (440) from the case cover.
  5. Inspect the input speed sensor (440) for the following conditions:
    • Damaged or missing magnet.
    • Damaged housing.
    • Bent or missing electrical terminals.
    • Damaged speed sensor clip (441).
Fig 1: Removing & Installing Input Shaft Speed Sensor
G00073400Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals