Steering Column Trim Covers - Disassemble - Off Vehicle (Floor Shift)

WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.

Tools Required: J 41352 Modular Column Holding Fixture

NOTE: Place the steering column in the CENTER position.

Remove the tilt knob from the lower trim cover.
Put the steering column and J 41352 into a vise.

Fig 1: Put Steering Column In A Vise
Courtesy of GENERAL MOTORS CORP.
Inspect the steering column for accident damage. Refer to Steering Column Accident Damage Inspection - Off Vehicle .
Remove the 2 pan head tapping screws (1) from the lower trim cover (2).

Fig 2: Pan Head Tapping Screws To The Lower Trim Cover
Courtesy of GENERAL MOTORS CORP.
Remove the lower trim cover from the upper trim cover.
Tilt the lower trim cover down.
Slide the lower trim cover backward in order to disengage the locking tabs.

Fig 3: Lower Trim Cover
Courtesy of GENERAL MOTORS CORP.
Remove the trim cover protector (1) from the lower trim cover (2).

Fig 4: Trim Cover Protector
Courtesy of GENERAL MOTORS CORP.
Remove the 2 TORX® head screws (1) from the upper trim cover (2).
Remove the upper trim cover (2) from the steering column.

Fig 5: Upper Trim Cover

Courtesy of GENERAL MOTORS CORP.