LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 549 (Steering Wheel And Steering Column) >> Repair Instructions >> Multifunction, Turn Signal, and Hazard Switch Replacement - On Vehicle >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Disable the SIR system. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM .
  3. Remove the steering wheel. Refer to Steering Wheel Replacement .
  4. Remove the steering column trim covers. Refer to Steering Column Trim Covers Replacement - On Vehicle .
  5. Remove the wire harness straps from the wire harness assembly on the steering column.
  6. Disconnect the multifunction switch assembly connector from the SIR coil assembly connector.
  7. Slide the multifunction switch assembly connectors (2) out of the steering column bulkhead connector (1).
    Fig 1: Multifunction Switch Assembly Connectors
    G01720242Courtesy of GENERAL MOTORS CORP.
  8. Remove the screws (1) from the multifunction switch assembly (2).
  9. Remove the multifunction switch assembly (2) from the steering column.
    10. Fig 2: Multifunction Switch Assembly Mounting Screws
    G01720243Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals