LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 547 (Power Steering System) >> Repair Instructions >> Power Steering Pressure Hose Replacement (3.8L) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the power steering pressure hose to the vehicle.
  2. Install the power steering pressure hose (2) to the clamps (1) on the power steering gear.
  3. Install the power steering pressure hose to the power steering pump.

    Tighten: 

    Tighten the fitting to 27 N.m (20 ft lbs) 

  4. Install the power steering pressure hose to the power steering gear.

    Tighten: 

    Tighten the pressure hose fitting to 27 N.m (20 ft lbs) 

  5. Install the tire and wheel assembly.
  6. Remove the drain pan from under the vehicle.
  7. Lower the vehicle.
  8. Install the accessory drive belt. Refer to SPECIFICATIONS & DRIVE BELT ROUTING .
  9. Fill the power steering system with power steering fluid. Refer to Checking and Adding Power Steering Fluid .
  10. Bleed the power steering system. Refer to Bleeding the Power Steering System .
  11. Inspect the power steering system for leaks. Refer to Power Steering Fluid Leaks .
scientia non olet · About LEMON Manuals