LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 544 (Rear Suspension System) >> Repair Instructions >> Wheel Bearing/Hub Replacement - Rear >> Removal Procedure (Disc Brakes)

Removal Procedure (Disc Brakes)

WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The wheel bearing in the rear wheel hub is integrated into one unit. The hub is non-serviceable. If the hub and/or bearing is damaged, replace the complete hub and bearing assembly.
  1. Raise and suitably support the vehicle.
  2. Remove the tires and wheels.
  3. Remove the brake rotor. Refer to Brake Rotor Replacement - Rear in Disc Brakes.
  4. Remove the ABS electrical connector from the wheel speed sensor (1), if equipped.
    Fig 1: Locating ABS Electrical Connector At Wheel Speed Sensor (Disc Brakes)
    G00379277Courtesy of GENERAL MOTORS CORP.
  5. Remove the park brake cable from the park brake actuator.
  6. Remove the mounting bolts from the rear bearing/hub.
  7. Remove the wheel bearing/hub and parking brake assembly from the knuckle.
    Fig 2: Wheel Bearing/Hub & Parking Brake Assembly (Disc Brakes)
    G00379278Courtesy of GENERAL MOTORS CORP.
  8. Remove the park brake actuator from the rear wheel bearing/hub. Refer to PARK BRAKE ACTUATOR .
scientia non olet · About LEMON Manuals