Repair Instructions: Knuckle: Installation
WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
- Install the knuckle to the vehicle. See Figure.
- Hand start the strut to knuckle bolts and nuts. Do not tighten the nuts at this time.
- Connect the rear suspension trailing arm to the knuckle. See Figure. See TRAILING ARM .
- Connect the rear wheel spindle rods to the knuckle. See SPINDLE ROD .
- Install the bearing/hub assembly. See WHEEL BEARING/HUB (REAR) . Tighten the strut to knuckle bolts to 122 N.m (90 lb ft).
- Install the tire and wheel assembly.
- Lower the vehicle.
- Inspect the rear wheel alignment, adjust if necessary. See SPECIFICATIONS .