LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 539 (Rear Suspension System) >> Repair Instructions >> Tie Rod Replacement (All Wheel Drive) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the tie rod.
    2. NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  2. Install the tie rod nut. Tighten the tie rod nut to 80 N.m (59 lb ft).
  3. Install the tie rod bolt. Tighten the tie rod bolt to 85 N.m (63 lb ft).
  4. Adjust the rear toe angle. Refer to Rear Toe Adjustment in Wheel Alignment .
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals