LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 538 (Suspension - General Diagnosis) >> Diagnostic Information >> Trim Height Inspection Procedure >> Z Height Adjustment

Z Height Adjustment

WARNING: This page is about a different car, the 2002 Cadillac Escalade EXT and 2002 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
  1. For vehicles equipped with a torsion bar suspension turn the bolt (1) that contacts the torsion arm as needed. One revolution of the bolt (1) into the nut increases the Z height by approximately 6.0 mm (0.2 in).
    Fig 1: Z Height Adjustment
    G00357777Courtesy of GENERAL MOTORS CORP.
  2. For vehicles without torsion bars, replace damaged or worn components as necessary.
  3. If these measurements are still out of specifications after adjustment or are not equipped with torsion bars, inspect for sagging front suspension or collision damage.
scientia non olet · About LEMON Manuals