LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 538 (Suspension - General Diagnosis) >> Diagnostic Information >> Trim Height Inspection Procedure >> Trim Height Measurements

Trim Height Measurements

WARNING: This page is about a different car, the 2002 Cadillac Escalade EXT and 2002 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.

Trim height is a predetermined measurement relating to vehicle ride height. Incorrect trim heights can cause bottoming out over bumps, damage to the suspension components and symptoms similar to wheel alignment problems. Check the trim heights when diagnosing suspension concerns and before checking the wheel alignment. Perform the following before measuring the trim heights:

  1. Make sure the vehicle is on a level surface, such as a alignment rack.
  2. Remove the alignment rack floating pins.
  3. Set the tire pressures to the pressure shown on the certification label.
  4. Check the fuel level. Add additional weight if necessary to simulate a full tank.
  5. Make sure the rear compartment is empty except for the spare tire.
  6. Close the doors and hood.

scientia non olet · About LEMON Manuals