Rear Lateral Links And Trailing Arms Replacement: Installation
WARNING: This page is about a different car, the 2002 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
- Install the front link to the vehicle. Install the Install the link bolt and nut at the rear suspension support. Tighten the rear link bolt to the suspension support 120 N.m (89 lb ft).
- Connect the ABS wire harness to the lateral link. Install the link to knuckle bolt, washer and the nut. Tighten the link to knuckle nut to 100 N.m (74 lb ft). Install the tire and wheel. Adjust the rear wheel alignment. Refer to MEASURING WHEEL ALIGNMENT in WHEEL ALIGNMENT .