LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 530 (Rear Suspension) >> Repair Instructions >> Wheel Bearing/Hub Replacement - Rear >> Installation

Wheel Bearing/Hub Replacement - Rear: Installation

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the wheel bearing/hub assembly to the steering knuckle.
    NOTE: Refer to FASTENER NOTICE .
  2. Install the wheel bearing/hub mounting bolts. Tighten the bolts to 84 N.m (62 lb ft).
  3. On all-wheel drive vehicles, install the wheel drive shaft spindle nut. Tighten the nut to 125 N.m (92 lb ft).
  4. If equipped, route the wheel speed sensor electrical harness through the backing plate and seat the grommet.
  5. Connect the wheel speed sensor electrical connector.
  6. Install the rear brake drum.
scientia non olet · About LEMON Manuals