Brake Fluid Loss
WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
- Were you sent here from DIAGNOSTIC STARTING POINT - HYDRAULIC BRAKES under TROUBLE SHOOTING? If so, go to next step. If not, see DIAGNOSTIC STARTING POINT - HYDRAULIC BRAKES under TROUBLE SHOOTING.
- Inspect the hydraulic brake system for proper operation. Did you find and correct a condition? If so, go to step 6 . If not, go to next step.
- Inspect the disc brake system for proper operation. Did you find and correct a condition? If so, go to step 6 . If not, go to next step.
- Separate the master cylinder from the vacuum brake booster. Do not disconnect any brake pipes. Inspect the rear of the master cylinder for a brake fluid leak. Inspect for brake fluid in the vacuum brake booster. Did you find a brake fluid leak? If so, go to next step. If not, go to DIAGNOSTIC STARTING POINT - HYDRAULIC BRAKES under TROUBLE SHOOTING.
- Replace the brake master cylinder and the vacuum brake booster. See MASTER CYLINDER under REMOVAL & INSTALLATION. After repairs are complete, go to next step.
- Install or connect components that were removed or disconnected during diagnosis. Road test the vehicle to confirm proper operation. Is the condition still present? If so, go to step 2 . If not, system is okay.