LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 52 (Disc Brakes) >> Removal & Installation >> Power Brake Booster >> Installation

Power Brake Booster: Installation

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the brake booster mounting gasket to booster, if removed previously. Install the vacuum brake booster to the vehicle.
  2. Install the vacuum brake booster pushrod to the brake pedal clevis pin. Install the foam spacer to the brake pedal clevis pin. Install the retaining clip to the brake pedal clevis pin. Install the booster stud mounting nuts to the booster studs and tighten to specifications. See TORQUE SPECIFICATIONS  . Install the left knee bolster. Install the left closeout insulator panel.
  3. Install the left carpet retainer. Install the inlet heater pipe. Install the shift control cable and bracket. Connect the shift control cable to the shaft lever pin. Shift the vehicle into park.
  4. Install the master cylinder to the vacuum brake booster. Install the master cylinder mounting nuts and tighten to specifications. See TORQUE SPECIFICATIONS  . Reposition and connect the vacuum check valve to the vacuum brake booster.
  5. Connect the electrical connector to the left strut tower. Install the cruise control module. Install the accelerator control cables and bracket. Install the air cleaner assembly. Remove the blocks from the front wheels. Release the park brake.


  1. Install the vacuum brake booster gasket to booster, if removed previously. Install the booster to the vehicle. Install the brake pedal to booster mounting stud nuts onto the booster studs and tighten to specifications. See TORQUE SPECIFICATIONS  .
  2. Install the booster pushrod to the brake pedal clevis pin. Install the brake pedal foam spacer to the brake pedal clevis pin. Install the retaining clip to the brake pedal clevis pin. Install the left knee bolster. Install the left closeout insulator panel.
  3. Install the master cylinder to the vacuum brake booster. See MASTER CYLINDER  . Install the secondary AIR injection crossover pipe.
  4. Connect the electrical connector to the cruise control on the left strut tower. Reposition and connect the vacuum check to the vacuum brake booster. Install the air cleaner assembly. Install the cruise control cable.
scientia non olet · About LEMON Manuals