Body Mount (Front): Installation
WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
- Tap the mount into the support assembly, ensuring the following conditions upon installation:
- The flat is outboard. See Fig 1.
- The notch is rearward.
- Use a large pair of channel lock pliers in order to bend the tabs outboard.
- Raise the support assembly to the body of the vehicle. See Figure.
- Install the bracket and bolts that secure the front of the support assembly to the vehicle body.
- Install the brackets retaining bolts to the body at the support assembly forward mounts.
- Tighten the bracket bolts to 63 Ft. Lbs. (86 N.m).
- Tighten the forward body mount retaining bolts to 141 Ft. Lbs. (191 N.m).
- Install the exhaust system.
- Install the tires and wheels.
- Lower the vehicle.