Passlock™ Theft Deterrent Relearn (Intrigue)

WARNING: This page does not describe the selected car, but rather 98 other vehicles, including the 2001 Saturn SW2, 2001 Saturn SL2, 2001 Saturn SL1, 2001 Saturn SL, and 2001 Saturn SC2. However, it is still accessible from the selected car via links, so may be relevant.

Password must be learned when Passlock™ sensor, BCM or PCM is replaced. This procedure must be performed after ignition switch replacement. If BCM is replaced, BCM must be programmed with proper RPO configurations before performing relearn procedures. If PCM is replaced, after programming, PCM will immediately learn the first password it receives. If password needs to be changed, learn procedure will need to be performed.

Turn ignition switch to OFF position. Turn ignition switch from OFF to START position, then leave turned to ON position. SECURITY indicator will come on and stay on for at least 10 minutes. After SECURITY indicator goes out, turn ignition off for 5 seconds. Repeat this procedure 2 more times. After third time, turn ignition off. Turn ignition switch to START position, engine should start and run. Recheck BCM for Diagnostic Trouble Codes (DTC).