LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 484 (Disc Brakes) >> Removal & Installation >> Rear Disc Brake Backing Plate >> Installation (1500 Series Utility Without 4-Wheel Steering)

Installation (1500 Series Utility Without 4-Wheel Steering)

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, and 2003 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the backing plate to the axle housing flange.
  2. Install the backing plate nuts.
  3. Tighten the backing plate nuts to specification. See TORQUE SPECIFICATIONS .
  4. Install the park brake shoe. See PARK BRAKE SHOES .
  5. Install the axle shaft. See AXLE SHAFTS under REMOVAL & INSTALLATION in the appropriate DIFFERENTIALS article in DRIVELINE/AXLES.
  6. Adjust the park brake shoe. See PARK BRAKE ADJUSTMENT  under ADJUSTMENTS & INSPECTION.
  7. Install the rotor. See BRAKE ROTOR .
  8. Install the rear park brake cable end to the park brake actuator lever.
  9. Install the park brake cable to the mounting bracket until the locking tabs snap into place.
  10. Install the park brake cable to the equalizer bar by pulling down on the cable in front of the equalizer and installing the cable to the equalizer bar.
  11. Install the tire and wheel assembly. Tighten to specification. See TORQUE SPECIFICATIONS .
  12. Lower vehicle.
  13. Adjust the park brake. See PARK BRAKE ADJUSTMENT  under ADJUSTMENTS & INSPECTION.
scientia non olet · About LEMON Manuals