LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 484 (Disc Brakes) >> Removal & Installation >> Park Brake Cable >> Installation (Right Rear - With 4-Wheel Steering)

Installation (Right Rear - With 4-Wheel Steering)

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, and 2003 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: When lifting the vehicle do not allow the jack to touch the rear steering gear. If the jack touches the rear steering gear you may damage the gear or the rack and pinion boots. If the boots are damaged replace the rack and pinion boot.
  1. Install the NEW brake cable into the rear brake cable mounting bracket by pushing the cable into place until the locking tabs snap into place. See Figure.
  2. Install the park brake cable to the lever. See Figure.
  3. Install the rear park brake cable bracket bolt. See Figure. Tighten the rear park brake cable bracket bolt to specification. See TORQUE SPECIFICATIONS .
  4. Install the park brake cable to the differential clip. See Figure.
  5. Install the park brake cable bolt to the rear axle clip. Tighten the park brake cable bolt to specification. See TORQUE SPECIFICATIONS .
  6. Install the park brake cable taking care to correctly route the cable though the guides and the body mounts. See Figure.
  7. Install the park brake cable into the mounting bracket until the locking tabs snap into place.
  8. Install the park brake cable to the equalizer bar. See Figure.
  9. Remove the safety stands.
  10. Lower the vehicle.
scientia non olet · About LEMON Manuals