LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 484 (Disc Brakes) >> Removal & Installation >> Park Brake Cable Mounting Bracket >> Removal

Park Brake Cable Mounting Bracket: Removal

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, and 2003 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release the parking brake.
  2. Raise and support the vehicle.
  3. Release the tension on the cables by loosening the nut at the equalizer. See Figure.
  4. Disconnect the rear cables from the equalizer.
  5. Remove the rear cables from the mounting bracket by depressing the retaining tabs and pulling rearward.
  6. Remove the cable support bracket nuts. See Fig 1.
  7. Remove the cable support bracket.
Fig 1: Removing Cable Support Bracket
G00317496Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals