LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 484 (Disc Brakes) >> Removal & Installation >> Park Brake Actuator >> Installation (1500 Series)

Installation (1500 Series)

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, and 2003 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the park brake actuator lever housing to the backing plate. See Figure.
  2. Perform the following procedure before installing the backing plate bolts:
    1. Remove all traces of the original adhesive patch.
    2. Clean the threads of the bolt with brake parts cleaner or the equivalent and allow to dry.
    3. Apply Threadlocker (GM P/N 12345493) to the threads of the bolt.
  3. Install the backing plate bolts. Tighten the backing plate bolts to specification. See TORQUE SPECIFICATIONS .
  4. Install the park brake shoe. See PARK BRAKE SHOES .
  5. Install the axle shaft. See AXLE SHAFTS under REMOVAL & INSTALLATION in the appropriate DIFFERENTIALS article in DRIVELINE/AXLES.
  6. Adjust the park brake shoe. See PARK BRAKE ADJUSTMENT  under ADJUSTMENTS & INSPECTION.
  7. Install the rotor. See BRAKE ROTOR .
  8. Install the rear park brake cable to the park brake actuator lever.
  9. Install the park brake cable to the mounting bracket until the locking tabs snap into place.
  10. Install the rear cables to the equalizer by pulling down on the intermediate cable and install the rear cables to the equalizer bar.
  11. Install the tire and wheel assembly. Tighten to specification. See TORQUE SPECIFICATIONS .
  12. Remove the safety stands.
  13. Lower vehicle.
  14. Adjust park brake cable. See PARK BRAKE ADJUSTMENT  under ADJUSTMENTS & INSPECTION.
scientia non olet · About LEMON Manuals