LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 484 (Disc Brakes) >> Removal & Installation >> Brake Hose >> Removal (Front)

Removal (Front)

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, and 2003 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle.
  2. Remove the tire and wheel assembly.
  3. Clean all dirt and foreign material from the brake hose end and brake pipe fitting.
    NOTE: Install a rubber cap or plug to the exposed brake pipe fitting end in order to prevent brake fluid loss and contamination. See Fig 1.
  4. Using a backup wrench on the brake hose fitting end, disconnect the brake pipe fitting end from the brake hose, then cap or plug the brake pipe fitting end.
  5. Remove the brake hose retaining clip from the brake hose mounting bracket.
  6. Remove the brake hose bracket bolt from the upper control arm.
  7. Remove the brake hose bracket bolt from the steering knuckle.
  8. Remove the brake hose to caliper bolt from the brake caliper. See Figure.
  9. Remove the brake hose from the brake caliper.
  10. Remove and discard the 2 copper brake hose gaskets. These gaskets may be stuck to the brake caliper housing or the brake hose end.
Fig 1: Capping Brake Pipe Fitting Ends
G00310163Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals