LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 484 (Disc Brakes) >> Adjustments & Inspections >> Park Brake Shoe Inspection

Park Brake Shoe Inspection

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, and 2003 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Prior to performing any work, review warnings, cautions and notes. See ADJUSTMENTS & INSPECTIONS WARNINGS, CAUTIONS & NOTES  under SERVICE PRECAUTIONS.
  1. Raise and support the vehicle.
  2. Remove the tire and wheel.
  3. Remove the rear brake caliper bracket with the rear brake caliper. See BRAKE CALIPER BRACKET  under REMOVAL & INSTALLATION.
  4. Remove the rear brake rotor. See BRAKE ROTOR  under REMOVAL & INSTALLATION.
  5. Inspect and replace the park brake shoe and lining if any excessive wear is indicated by the park brake lining being worn down to the shoe, the brake lining is cracking or if there is oil or fluid contamination of the brake lining.
  6. Adjust the park brake shoe. See PARK BRAKE ADJUSTMENT .
  7. Install the rear brake rotor. See BRAKE ROTOR  under REMOVAL & INSTALLATION.
  8. Install the rear brake caliper with the rear brake caliper bracket. See BRAKE CALIPER BRACKET  under REMOVAL & INSTALLATION.
  9. Install the tire and wheel. Tighten to specification. See TORQUE SPECIFICATIONS .
  10. Lower the vehicle.
scientia non olet · About LEMON Manuals