LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 483 (Disc Brakes (Cab & Chassis, & Hd)) >> Removal & Installation >> Brake Pedal Assembly >> Removal

Brake Pedal Assembly: Removal

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the pushrod retainer from the brake pedal pin. See Fig 1 .
  2. Remove the stop light switch from the brake pedal pushrod pin.
  3. Remove the pushrod from the brake pedal pin.
  4. Remove the bolts that retain the instrument panel center support bracket to the steering column bracket. See Fig 2 .
  5. Remove the bolt that retains the reinforcement to the instrument panel center support bracket.
  6. Disconnect the electrical connector from the remote control door lock receiver.
  7. Remove the instrument panel center support bracket.
  8. Remove the brake pedal nut. See Fig 3 .
  9. Remove the brake pedal bolt.
  10. Remove the brake pedal.
  11. Remove the bushings and the spacer from the brake pedal.
Fig 1: Removing Pushrod Retainer
G00317528Courtesy of GENERAL MOTORS CORP.
Fig 2: Removing Instrument Panel Center Support Bracket
G00317529Courtesy of GENERAL MOTORS CORP.
Fig 3: Removing Pedal Nut & Bolt
G00317530Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals