Brake Shoe: Removal
WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
- Raise and support the vehicle.
- Remove the brake drum. See BRAKE DRUM .
- Disengage the adjuster spring hook end from the tab on the adjuster actuator. See Figure.
- Remove the straight end of the adjuster spring from the brake shoe.
- Remove the adjuster actuator from the brake shoe.
- Remove the return spring from the brake shoes.
- Remove the park brake cable from the park brake actuator lever.
- Remove the brake shoe hold-down springs and retainers from the brake shoes.
- Remove the adjuster from the brake shoes and the park brake actuator lever.
- Remove the horseshoe clip retaining the park brake actuator lever to the brake shoe.
- Remove the park brake actuator lever and wave washer from the brake shoe.
- Clean all of the drum brake system components with denatured alcohol.
- Inspect all of the drum brake system components. See DRUM BRAKE HARDWARE INSPECTION and DRUM BRAKE ADJUSTING HARDWARE INSPECTION under REAR DRUM BRAKE in ADJUSTMENTS & INSPECTION.
- Replace drum brake system components as necessary. See BRAKE HARDWARE .
- Inspect the wheel cylinder for the following conditions:
- Brake fluid leakage
- Worn or damaged dust boots
- Replace damaged or leaking wheel cylinders as necessary. See WHEEL CYLINDER .
CAUTION:
Do not over stretch the adjuster spring. Damage can occur if the spring is over stretched.