LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 469 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Brake Pedal Assembly >> Installation

Brake Pedal Assembly: Installation

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the cruise control release switch, if equipped, and the stoplight switch to the brake pedal with the bracket.
  2. Install the brake pedal brace with the mounting nuts to the bracket. See Figure. Tighten the nuts to specification. See TORQUE SPECIFICATIONS .
  3. Install the brake pedal with the bracket.
  4. Install the upper mounting bolt for the brake pedal brace. Tighten the bolt to specification. See TORQUE SPECIFICATIONS .
  5. Install the brake pedal bracket mounting nuts. Tighten the nuts to specification. See TORQUE SPECIFICATIONS .
  6. Install the brake booster mounting nuts. Tighten the nuts to specification. See TORQUE SPECIFICATIONS .
  7. Install the knee bolster.
  8. Connect the electrical connectors to the cruise control release if equipped and stoplight switch.
  9. Install the booster push rod to the brake pedal.
  10. Adjust the stoplight switch and the cruise control release switch if equipped. See STOPLIGHT SWITCH  under ADJUSTMENTS & INSPECTION.
  11. Install the left side insulator panel.
  12. Enable the SIR system. See appropriate AIR BAG RESTRAINT SYSTEMS article in RESTRAINTS.
scientia non olet · About LEMON Manuals