LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 469 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Brake Hardware >> Removal (Rear) Disc

Removal (Rear) Disc

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect the fluid level in the brake master cylinder reservoir.
  2. If the brake fluid level is midway between the maximum-full point and the minimum allowable level, then no brake fluid needs to be removed from the reservoir before proceeding. If the brake fluid level is higher than midway between the maximum-full point and the minimum allowable level, then remove brake fluid to the midway point before proceeding.
  3. Raise and support the vehicle.
  4. Remove the tire and wheel.
  5. Using a C-clamp installed to the center of the outer disc brake pad and the back of the caliper, slowly compress the caliper piston into its bore just enough to remove the caliper from the mounting bracket.
  6. Remove the C-clamp from the brake caliper.
  7. Use a strap or heavy gage wire in order to support the brake caliper and the brake caliper bracket.
  8. Remove the disc brake caliper from the mounting bracket.
  9. Remove the disc brake pads from the disc brake caliper bracket.
  10. Remove the disc brake pad retainers from the disc brake caliper bracket.
  11. Remove the brake rotor.
scientia non olet · About LEMON Manuals