LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 469 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Brake Caliper >> Installation (Rear)

Installation (Rear)

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ensure that the caliper bolt bushings and the caliper bolt boots are properly installed.
  2. Install the brake caliper to the brake caliper bracket.
  3. Lubricate the brake caliper bolt shaft. DO NOT lubricate the threads.
  4. Lubricate the brake caliper bolt boots in the brake caliper bracket.
  5. Install the brake caliper bolts. Tighten the brake caliper bolts to specification. See TORQUE SPECIFICATIONS .
  6. Use a flat-bladed tool in order to install the brake caliper bracket boot over the shoulder of the brake caliper bolt.
  7. Remove the plugs in the brake hose end.
  8. Assemble the brake hose bolt and the NEW copper brake hose gaskets to the brake hose.
  9. Install the brake hose bolt to the brake caliper. See BRAKE HOSE .
  10. Remove the nuts securing the rotor to the hub.
  11. Install the tire and wheel.
  12. Lower the vehicle.
  13. Fill the master cylinder to the proper level. See MASTER CYLINDER RESERVOIR  under BLEEDING, FILLING & FLUSHING BRAKE SYSTEM.
  14. Bleed the brake system. See HYDRAULIC BRAKE SYSTEM BLEEDING  under BLEEDING, FILLING & FLUSHING BRAKE SYSTEM.
  15. Apply approximately 175 ft lbs (778 N.m) of force to the brake pedal for ten seconds.
  16. Inspect the brake caliper and hydraulic brake system for brake fluid leaks.
scientia non olet · About LEMON Manuals