LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 468 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Disc Brake Splash Shield - Front >> Installation

Disc Brake Splash Shield - Front: Installation

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the splash shield.
  2. Install the hub and bearing assembly. See REMOVAL & INSTALLATION in FRONT SUSPENSION article in SUSPENSION.
  3. Install the tire and wheel assembly.
  4. Lower the vehicle.
  5. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
  6. Slowly release the brake pedal.
  7. Wait 15 seconds, then repeat steps  5 and  6 until a firm brake pedal is obtained. This will properly seat the brake caliper pistons and brake pads.
scientia non olet · About LEMON Manuals