LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 468 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Brake Rotor - Front >> Removal

Brake Rotor - Front: Removal

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle.
  2. Remove the tire and wheel assembly.
  3. On 2 wheel drive vehicles, remove the brake caliper. See BRAKE CALIPER - FRONT SINGLE PISTON  or BRAKE CALIPER - FRONT DUAL PISTON  .
  4. On 4 wheel drive vehicles, remove the brake caliper and mounting bracket. See BRAKE CALIPER BRACKET - FRONT .
  5. On 4 wheel drive vehicles, remove retaining ring.
  6. On 4 wheel drive vehicles, remove the brake rotor.
  7. On 2 wheel drive vehicles, remove brake rotor and wheel bearings. See REMOVAL & INSTALLATION in FRONT SUSPENSION article in SUSPENSION.
  8. On all vehicles, inspect the brake rotor. See DISC ROTOR SURFACE AND WEAR INSPECTION  under ADJUSTMENTS & INSPECTION.
  9. Inspect the brake caliper. See DISC CALIPER INSPECTION  under ADJUSTMENTS & INSPECTION.
  10. Refinish the rotor if necessary.
scientia non olet · About LEMON Manuals