LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 468 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Brake Pads - Front Dual Piston Caliper >> Installation

Brake Pads - Front Dual Piston Caliper: Installation

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the new anti rattle retainers.
  2. Install the outboard brake pad. See Figure.
  3. Install inboard brake pad. See Figure.
  4. Remove the brake caliper from the support.
  5. Install the brake caliper. See BRAKE CALIPER - FRONT DUAL PISTON .
  6. Install the tire and wheel assembly.
  7. Lower the vehicle.
  8. Fill the brake master cylinder to the proper level. See MASTER CYLINDER RESERVOIR FILLING  under BLEEDING.
  9. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
  10. Slowly release the brake pedal.
  11. Wait 15 seconds, then repeat steps  9 and  10 until a firm brake pedal is obtained. This will properly seat the brake caliper pistons and brake pads.
  12. Burnish the new brake pads. See BURNISHING PADS AND ROTORS  under SERVICING.
scientia non olet · About LEMON Manuals