LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 468 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Brake Caliper Bracket - Rear >> Installation

Brake Caliper Bracket - Rear: Installation

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the caliper bracket.
  2. Install the rear brake caliper bracket mounting bolts. Tighten the rear brake caliper bracket mounting bolts to specification. See TORQUE SPECIFICATIONS .
  3. Install the rear brake anti rattle retainers.
  4. Install the rear brake pads. See BRAKE PADS - REAR .
  5. Install the tire and wheel assembly.
  6. Lower the vehicle.
  7. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
  8. Slowly release the brake pedal.
  9. Wait 15 seconds, then repeat steps  6 and  7 until a firm brake pedal is obtained. This will properly seat the brake caliper pistons and brake pads.
  10. Fill the brake master cylinder to the proper level. See MASTER CYLINDER RESERVOIR FILLING  under BLEEDING.
scientia non olet · About LEMON Manuals