LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 468 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Adjusting Screw >> Installation

Adjusting Screw: Installation

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate the brake shoe backing plate, the adjusting screw threads, socket and socket face with a thin coat of high temperature silicone lubricant.
  2. Install the adjusting screw assembly and the adjusting screw spring on the brake shoes. The coils of the adjusting screw spring must not touch the adjusting screw.
  3. Install the brake shoes on the backing plate.
  4. Install the strut spring on the park brake strut.
  5. Install the park brake strut.
  6. Install the actuator lever and the lever pivot.
  7. Install the actuator lever return spring.
  8. Install the hold down pins.
  9. Install the hold down springs.
  10. Install the brake shoe guide.
  11. Install the brake shoe return springs.
  12. Install the brake drum. See BRAKE DRUM .
  13. Install the tire and wheel assembly.
  14. Adjust the brakes. See DRUM BRAKE ADJUSTMENT  under ADJUSTMENTS & INSPECTION.
  15. Lower the vehicle.
scientia non olet · About LEMON Manuals