LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 468 (Disc Brakes & Drum Brakes) >> Overhaul >> Brake Caliper - Rear >> Assembly

Brake Caliper - Rear: Assembly

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate the new piston seal, the caliper bore, and the piston with clean brake fluid.
  2. Install the piston seal. Make sure the piston seal is not twisted in the caliper bore groove.
  3. Install the boot into the caliper housing bore by hand.
  4. Install the piston in the caliper bore. Push the piston to the bottom of the bore by hand.
  5. Install the boot on the piston.
Fig 1: Exploded View Of Single Piston Caliper Assembly
G00030580Courtesy of GENERAL MOTORS CORP.
Fig 2: Exploded View Of Dual Piston Caliper Assembly
G00030581Courtesy of GENERAL MOTORS CORP.
Fig 3: Exploded View Of Rear Brake Shoe Assembly
G95H27109Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals