Hydraulic Brake System Flushing

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.

Inspect the brake fluid for the following conditions, indicating brake fluid contamination:
- Fluid separation - indicating 2 types of fluid are present; a substance other than the recommended brake fluid has been introduced into the brake hydraulic system. Swirled appearance, oil-based substance. Layered appearance, silicone-based substance.
- Fluid discoloration - indicating the presence of moisture or particles that have been introduced into the brake hydraulic system. Cloudy appearance, moisture. Dark appearance or suspended particles in fluid, dirt/rust/corrosion/brake dust.
Inspect the master cylinder reservoir cap diaphragm and the reservoir-to-master cylinder grommets for swelling, indicating brake fluid contamination.
If the brake fluid was contaminated with an oil-based or a silicone-based substance, indicated by fluid separation and/or a swollen master cylinder reservoir cap diaphragm and/or swollen reservoir-to-master cylinder grommets, perform the following:
- Remove all of the following components listed from the vehicle. Each component contains internal rubber seals/linings which have been contaminated by the contaminated brake fluid in the brake hydraulic system. See
  1. Master Cylinder Replacement
  2. Brake Hose
  3. Brake Caliper - Front Single Piston
  4. Brake Caliper - Front Dual Piston
  5. Brake Caliper - Rear
  6. Wheel Cylinder
  under REMOVAL & INSTALLATION . Also see BRAKE PRESSURE MODULATOR VALVE under REMOVAL & INSTALLATION in appropriate ANTI-LOCK article.
- Clean out all the hydraulic brake pipes using denatured alcohol, or equivalent.
- Dry the brake pipes using non-lubricated, filtered air.
- Repair or replace all of the following components listed and install them to the vehicle. Each component contains internal rubber seals/linings which have been contaminated by the contaminated brake fluid in the brake hydraulic system: See the following components under REMOVAL & INSTALLATION and/or OVERHAUL .
  1. Master Cylinder
  2. Master Cylinder Reservoir
  3. Brake Hose
  4. Brake Caliper - Front Single Piston
  5. Brake Caliper - Front Dual Piston
  6. Brake Caliper - Rear
  7. Wheel Cylinder
  Clean the brake master cylinder reservoir using denatured alcohol, or equivalent, then dry the reservoir using non-lubricated, filtered air. Inspect the reservoir for cracks and/or damage and replace if necessary. Also see BRAKE PRESSURE MODULATOR VALVE under REMOVAL & INSTALLATION in appropriate ANTI-LOCK article.
If the brake fluid was not contaminated with an oil-based or a silicone-based substance, but was contaminated with water or dirt, rust, corrosion, and/or brake dust, replace the brake master cylinder reservoir cap diaphragm. The diaphragm may have allowed the moisture or particles to enter the hydraulic system.
Fill the brake master cylinder reservoir to the maximum-fill level with Delco Supreme 11®, GM P/N 12377967, or equivalent DOT-3 brake fluid from a clean, sealed brake fluid container.
Pressure bleed the hydraulic brake system. Begin the procedure with the pressure bleeder reservoir filled to the maximum-fill level with the correct brake fluid as indicated. See HYDRAULIC BRAKE SYSTEM - MANUAL or HYDRAULIC BRAKE SYSTEM - PRESSURE .