LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 457 (Engine Mechanical - 6.6L V8 Diesel) >> Removal & Installation >> Rear Crankshaft Oil Seal >> Installation

Rear Crankshaft Oil Seal: Installation

WARNING: This page is about a different car, the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, and 2003 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The Crankshaft Rear Oil Seal Installer (J-44642) must be fully secured to crankshaft to ensure proper seal depth.
  1. Clean crankshaft of oil and dirt. Clean seal bore in flywheel housing. Place crankshaft rear oil seal onto crankshaft.
  2. Install crankshaft rear oil seal installer to crankshaft. Press crankshaft rear oil seal into position using crankshaft rear oil seal installer. The crankshaft rear oil seal installer will bottom out when seal reaches proper depth. Remove crankshaft rear oil seal installer.
  3. Install flywheel assembly. Tighten bolts to specification.See TORQUE SPECIFICATIONS .
scientia non olet · About LEMON Manuals