Rear Seal Installation (2WD Only)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, 2003 Chevrolet Cab & Chassis Silverado, and 2002 GMC Sierra. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: For transmissions without parking brake provision, use Output Shaft Seal Installer (J-43782) or equivalent. For transmissions with parking brake provision, use Output Shaft Seal Installer (J-43783) or equivalent.

Install oil seal assembly. On transmissions without parking brake provision, ensure seal is installed to .179-.211" (4.55-5.35 mm) below rear face of rear cover. On transmissions with parking brake provision, ensure seal is installed to 1.224-1.256" (31.10-31.90 mm) below rear face of rear cover.