LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 441 (Air Bag Restraint Systems) >> Removal & Installation >> Air Bag Modules >> Removal & Installation (Driver-side)

Removal & Installation (Driver-side)

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disable air bag system. See DISABLING & ACTIVATING AIR BAG SYSTEM .
  2. Remove upper steering column cover. Turn steering wheel to 3 o'clock position. Insert stubby flat-blade screwdriver into triangular hole on rear of steering wheel. While pulling on corner of air bag module, turn screwdriver to release spring retainer. Repeat procedure for remaining 3 retainers. Disconnect driver-side air bag module electrical connector. Remove driver-side air bag module. See Fig 1.
  3. To install, reverse removal procedure. Ensure all driver-side air bag module spring retainers are attached securely. Activate air bag system.
Fig 1: Identifying Driver-side Air Bag Module
G99B26238Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals