LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 44 (HVAC Systems - Manual) >> Removal & Installation >> Compressor >> Installation (4.8L, 5.3L, 6.0L With Denso - Avalanche, Escalade, Suburban, Tahoe, Yukon)

Installation (4.8L, 5.3L, 6.0L With Denso - Avalanche, Escalade, Suburban, Tahoe, Yukon)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Add the proper amount of PAG oil to the compressor crankcase. See SPECIFICATIONS . Install the A/C compressor to the bracket through the fender well. Insert the mounting bolt into the lower right mounting boss before installing the A/C compressor. See Figure. Install the A/C compressor to the bracket. Insert the mounting bolt into the lower right mount before installing the A/C compressor.
  2. Install the A/C compressor mounting bolts. Tighten to specification. Connect the electrical connector to the A/C compressor. Install the A/C discharge hose to the compressor using new sealing washers. See SEALING WASHER . Install the A/C discharge hose bolt to the A/C compressor. Tighten to specification. See TORQUE SPECIFICATIONS .
  3. Install the A/C suction hose to the compressor using new sealing washers. See SEALING WASHER . Install the A/C suction hose bolt to the A/C compressor. Tighten to specification.
  4. Install the wheel house panel to the vehicle. Install the right front tire and wheel assembly.
  5. Install the A/C drive belt. Evacuate and recharge the A/C system. See RECOVERY/EVACUATION & RECHARGING in GENERAL SERVICING PROCEDURES article in GENERAL SERVICING. Leak test the fittings of the component using a Leak Detector.
scientia non olet · About LEMON Manuals