LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 438 (Supplemental Inflatable Restraint System) >> Removal & Installation >> Air Bag Modules >> Removal & Installation (Driver-side)

Removal & Installation (Driver-side)

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disable air bag system. See ZONE 3  under DISABLING & ACTIVATING AIR BAG SYSTEM.
  2. Remove 4 driver-side air bag module bolts from back of steering wheel. Partially remove air bag module from steering wheel. See Fig 1.
  3. Remove Connector Position Assurance (CPA) clip from air bag module connector. Disconnect air bag module connector. Disconnect horn wiring harness and ground lead from steering wheel. Remove driver-side air bag module.
  4. To install, reverse removal procedure. Tighten driver-side air bag module bolts to specification. See TORQUE SPECIFICATIONS . Activate air bag system. See ZONE 3  under DISABLING & ACTIVATING AIR BAG SYSTEM.
Fig 1: Identifying Driver-side Air Bag Module
G98E13544Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals