LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 435 (Supplemental Inflatable Restraint System) >> Removal & Installation >> Air Bag Modules >> Removal & Installation (Passenger-side)

Removal & Installation (Passenger-side)

WARNING: This page is about a different car, the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, and 2003 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disable air bag system. See ZONE 5  under DISABLING & ACTIVATING AIR BAG SYSTEM.
  2. Remove instrument panel upper trim pad. See INSTRUMENT PANEL UPPER TRIM PAD . Remove Connector Position Assurance (CPA) clip from passenger-side air bag module connector. See Figure. Disconnect passenger-side air bag module connector. Remove passenger-side air bag module bolts. Remove passenger-side air bag module from instrument panel. See Fig 1.
  3. To install, reverse removal procedure. Tighten passenger-side air bag module bolts and trim panel screws to specification. See TORQUE SPECIFICATIONS . Activate air bag system. See ZONE 5  under DISABLING & ACTIVATING AIR BAG SYSTEM.
Fig 1: Identifying Passenger-side Air Bag Module
G99H00387Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals