LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 434 (Supplemental Inflatable Restraint System) >> Removal & Installation >> Air Bag Modules >> Removal & Installation (Passenger-side)

Removal & Installation (Passenger-side)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disable air bag system. See ZONE 5  under DISABLING & ACTIVATING AIR BAG SYSTEM.
  2. Remove instrument panel upper trim pad. See INSTRUMENT PANEL UPPER TRIM PAD . Remove Connector Position Assurance (CPA) clip from air bag module connector and disconnect passenger-side air bag module connector. Remove passenger-side air bag module mounting bolts. Remove passenger-side air bag module from instrument panel. See Fig 1.
  3. To install, reverse removal procedure. Install passenger-side air bag module upper bolts first. Tighten passenger-side air bag module mounting bolts and instrument panel upper trim pad screws to specification. See TORQUE SPECIFICATIONS . Activate air bag system. See ZONE 5  under DISABLING & ACTIVATING AIR BAG SYSTEM.
Fig 1: Identifying Passenger-side Air Bag Module
G99H00387Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals