EGR Valve Pipe: Installation

WARNING: This page is about a different car, the 2003 Pontiac Grand Prix, 2003 Chevrolet Monte Carlo, 2003 Chevrolet Impala, 2003 Buick Regal, and 2003 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.

Install the EGR valve inlet pipe assembly. Install the mounting bolt and the stud to the EGR valve inlet pipe bracket. Tighten the bolt and stud to specification. See TORQUE SPECIFICATIONS .
Install the EGR valve inlet pipe bolt to the exhaust manifold. Tighten the bolt to specification.. Install the EGR valve outlet pipe. See REMOVAL (3.8L - OUTLET PIPE) .
If applicable, install the AIR pump outlet pipe. See SECONDARY AIR INJECTION PUMP OUTLET PIPE/HOSE . Install the EGR valve. See EGR VALVE .

Fig 1: Removing/Installing EGR Valve Inlet Pipe (3.8L)

Courtesy of GENERAL MOTORS CORP.