Tie Rod End (Inner): Installation

WARNING: This page is about a different car, the 2002 Pontiac Grand Am, 2002 Oldsmobile Alero, and 2002 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Make sure the shock dampener is on the rack before installing the inner tie rod. The threads must be clean prior to the Loctite(R) application. Check the Loctite(R) (or equivalent) container for expiration date. Use only enough Loctite(R) to evenly coat the threads.

Apply Loctite(R) 262 (or equivalent) to the inner tie rod threads. Install the inner tie rod to the rack and pinion. Install a torque wrench to the Inner Tie Rod Wrench (J-34028) to tighten the inner tie rod. Hold the rack while tightening the tie rod as shown. To complete installation, reverse removal procedure.