LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 424 (Engine Controls - Removal & Installation - Gasoline) >> Torque Specifications >> 4.8L, 5.3L & 6.0L

4.8L, 5.3L & 6.0L

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS (4.8L, 5.3L & 6.0L)

Component Ft. Lbs. (N.m)
Accelerator Pedal Mounting Bolts 15 (20)
Air Cleaner Assembly Bolt 13 (17)
AIR Pump Mounting Bolt 13 (17)
Camshaft Position Sensor Bolt 21 (29)
Coolant Hose Nipple 13 (17)
Crankshaft Position Sensor 18 (25)
Distributor Mounting Clamp Bolt 18 (25)
EGR Pipe Bracket Retaining Fastener 18 (25)
EGR Pipe Fitting-To-Cylinder Head Bolts 37 (50)
EGR Pipe Fitting-To-Exhaust Manifold 18 (25)
EGR Tube Retaining Bolt 18 (25)
EGR Valve Attaching Bolt (1)
Engine Coolant Temperature Sensor 15 (20)
EVAP Canister Bracket Bolt 18 (25)
EVAP Canister Mounting Bolt 18 (25)
Fuel Filler Bracket Bolt 9 (12)
Fuel Filter Fitting 20 (27)
Fuel Pipe Fittings-To-Engine 20 (27)
Fuel Pipe Nuts (Feed & Return) 22 (30)
Fuel Pipe Retaining Nuts-To-Engine 21 (28)
Fuel Rail Attaching Bolt (Front Stud) 18 (25)
Fuel Rail Stop Bracket Bolt 37 (50)
Fuel Tank Strap Bolts 15 (20)
Generator Bolt 37 (50)
Generator Bracket Bolts 37 (50)
Ground Harness Bolt 18 (25)
Heated Oxygen Sensor (HO2S) 31 (42)
Ignition Coil Bracket-To-Valve Rocker Arm Cover Bolts 9 (12)
Knock Sensor (KS) 15 (20)
Spark Plug-Iron Head-New Head 22 (30)
Spark Plug-Iron Head-Used Head 11 (15)
Throttle Cable Bracket Bolt 18 (25)
INCH Lbs. (N.m) 
Accelerator Control Cable Bracket Bolt 89 (10)
Air Cleaner Adapter Stud 71 (8)
Air Inlet Duct Retaining Nut 18 (2)
Coil Bracket Screw 11 (97)
Crankshaft (CKP) Sensor Hold-Down Bolt 71 (8)
Distributor Cap Screw 21 (2.4)
Distributor Hold-Down Bolt 27 (3)
EGR Pipe Fitting-To-Intake Manifold 106 (12)
Engine Wiring Harness Retaining Nut 49 (5.5)
EVAP Canister Mounting Nuts 89 (10)
EVAP Canister Purge Valve Shoulder Bolt 93 (10.5)
EVAP Canister Vent Valve Bracket Mount Bolt 106 (12)
EVAP Purge Solenoid Bolt 89 (10)
Fuel Fill Hose Clamp Bolt 24 (2.75)
Fuel Fill Pipe Bracket Bolt 53 (6)
Fuel Fill Pipe Ground Strap Bolt 80 (9)
Fuel Fill Pipe Housing-To-Fill Pipe Bolts 20 (2.3)
Fuel Fill Vent Hose Clamps 24 (2.75)
Fuel Injection Lower Hold-Down Plate & Nut 27 (3)
Fuel Meter Body Retaining Bracket Bolts - Intake Manifold 89 (10)
Fuel Rail Attaching Bolts 89 (10)
Fuel Rail Crossover Pipe Retainer Clip Hatching Screw 34 (3.8)
Fuel Rail Attaching Bolt (Center Bolt) 89 (10)
Fuel Rail Attaching Bolt (Rear Bolt) 89 (10)
Fuel Return Pipe Attaching Screw 44 (5)
Fuel Tank Filler Neck Clamp 24.3 (2.75)
Generator Output Terminal Nut 80 (9)
Idle Air Control (IAC) Attaching Screw 27 (3)
Intake Manifold Sight Shield Fasteners 89 (10)
Intake Manifold Bolts (2)
Intake Manifold Wiring Harness Stud 89 (10)
Ignition Coil-To-Bracket Bolts 71 (8)
Ignition Control Module (ICM) Attaching Screw 31 (3.5)
Mass Airflow (MAF)/Intake Air Temperature (IAT) Attaching Bolts 97 (11)
Powertrain Control Module (PCM) Connector End Fastener 71 (8)
Power Brake Fitting 115 (13)
Pressure Regulator Screw 80 (9)
Rear Fuel Line Bracket Retaining Bolt 53 (6)
Throttle Body Attaching Bolts & Nuts 89 (10)
Throttle Position (TP) Screw 18 (2)
Upper Engine Wiring Harness Nut 49 (5.5)
(1) Tighten EGR valve bolt to 89 INCH lbs. (10 N.m) on the first pass. Tighten the bolts to 18 ft. lbs. (25 N.m) on the final pass.
(2) Tighten intake manifold bolts in sequence to 44 INCH lbs. (5 N.m) on the first pass. Tighten the intake manifold bolts in sequence to 89 INCH lbs. (10 N.m).