LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 421 (Engine Mechanical - 4.8L, 5.3L, & 6.0L (On-Vehicle)) >> Repair Instructions >> Engine Mount Replacement - Right >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Right Engine Mount & Bolts
    GM307279Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  1. Position the right engine mount to the engine.
  2. Install the engine mount bolts.

    Tighten:  Tighten the engine mount bolts to 50 N.m (37 lb ft).

  3. Lower the engine.
  4. Remove the adjustable jack stands.
    5. Fig 2: View Of Engine Mount-To-Engine Mount Bracket
    GM307275Courtesy of GENERAL MOTORS CORP.
  5. Install the engine mount-to-engine mount bracket bolts.

    Tighten:  Tighten the engine mount-to-engine mount bracket bolts to 65 N.m (48 lb. ft.).

  6. Install the exhaust manifold. Refer to EXHAUST MANIFOLD REPLACEMENT - RIGHT (4.8L, 5.3L, AND 6.0L ENGINES) or EXHAUST MANIFOLD REPLACEMENT - RIGHT (8.1L ENGINE) in Engine Exhaust.
  7. Install the inner wheelhouse panel. Refer to Refer to WHEELHOUSE PANEL REPLACEMENT in Body Front End.
  8. Install the tire and wheel. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION in Tires and Wheels.
  9. Install the engine protection shield, if equipped. Refer to ENGINE PROTECTION SHIELD REPLACEMENT in Frame and Underbody.
  10. Lower the vehicle.
scientia non olet · About LEMON Manuals