LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 417 (Engine Mechanical - 6.5L (On-Vehicle)) >> Removal & Installation >> Drive Belt >> Installation

Drive Belt: Installation

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, 2002 Chevrolet RV Cutaway, and 2002 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the belt over all the pulleys except the tensioner arm. See Figure and Figure .
  2. Install a 3/8" drive wrench on the tensioner arm and rotate the arm counterclockwise. Slowly release the tension on the tensioner arm. Inspect for the drive belt being properly install on the pulleys. Avoid mispositioning the drive belt by one or more grooves.
  3. Confirm for the proper drive belt size and the correct drive belt routing by observing the location of the fix pointer and index marks on the drive belt tensioner. With a new drive belt installed the fix pointer should align within the indentation on the drive belt tensioner. With a used drive belt installed the fix pointer should not align past the index marks.
  4. Install the coolant recovery bottle. Install the air cleaner assembly.
scientia non olet · About LEMON Manuals