LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 417 (Engine Mechanical - 6.5L (On-Vehicle)) >> Engine Oiling >> Oil Level Indicator & Tube >> Installation

Oil Level Indicator & Tube: Installation

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, 2002 Chevrolet RV Cutaway, and 2002 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the new O-ring seal to the oil level indicator tube. Install the lower section of the oil indicator tube. Install the bolt retaining the oil level indicator tube to the valve rocker arm cover. Tighten the oil level indicator tube bolt to specifications. See TORQUE SPECIFICATIONS .
  2. Install the left exhaust manifold. See EXHAUST MANIFOLD  under REMOVAL & INSTALLATION. Install a small amount of RTV sealant GM P/N 12346286 to the area on the upper tube where it joins with the lower tube.
  3. Install the upper oil level indicator tube. Install the nut retaining the oil level indicator tube to the thermostat cross over. Tighten the oil level indicator tube nut to specifications. See TORQUE SPECIFICATIONS .
  4. Install the oil level indicator. Install the surge tank. Tighten the surge tank bolt to specifications. See TORQUE SPECIFICATIONS . Install the air cleaner assembly and air intake duct. Install the interior engine cover (if equipped).
scientia non olet · About LEMON Manuals